Reconnecting Wi-Fi (off/on) of the client helps.
After a few hours wi-fi client cannot get working network (icmp ping to router, tcp failed) while being connected to Wi-Fi. GUI install, with reverting all settings. Recently upgraded from a two-year-old r31690. Status: generally ok, connection problems (see below) Is this issue just affect router which manually added br1 br2 etc other than br0? Or this issue happens on the router with just the default br0 and no other bridges as well?įile: dd-wrt.v24-40260_NEWD-2_K3.x_mega-nv64k.bin I'm sure the logfile(s) would help determine the problem, if it's in the firmware. Posted: Fri 20:16 Post subject: Re: Netgear WNR3500L v2 I think is some problem with security in this firmware build. I'm block this IP in iptables, block ports in port triggering. IP from the world try operation on 19 port.
Router have something problem cause I have UDP bad checksum one event in device log. When I'm change options there and click save and apply settings button configuration back to default values, so I can't change network ports configuration. I can't make configure in Basic -> Switch config tab. On the AC3200 I have a bridged VAP on a VLAN and it works fine on startup or reset without issuing the startup commands or doing it manually. Someone in the Kong's new build said (again?) VAP was fixed, no work-around needed. even though the VAP does broadcast after reboot.Īnd yea I know there is various startup commands you can use to make it work besides having to go into the webif but that ain't the point. Just some minor testing - wired clients to 'Repeater' mode router is fine but wireless clients CANNOT connect to its VAP
BCM4360 DD WRT INSTALL
VAP ( all its functions) not fully start after an install or reboot. Might be worth someone checking on BS builds to confirm tho.Īll three of the units - same ol broadcom buggy VAP crap been there long time now. But if the VAP if bridged to ie br1, then the startup commands are still needed. What I've found with recent Kong & BS builds for the R7000 is that VAP startup commands don't need to be used for an unbridged VAP. I can't comprehend why a MacDonald restaurant just keep trying to make curry sushi and never give a f**k about their own hamburger taste like shit.
BCM4360 DD WRT UPDATE
You are not alone, and I've update that isuue and provide more info again, agree this is still a serious issue for broadcom soc routers as well, and actually for a very long long time already (since a long time ago. Didn't test on the E3000, but I spent hours before I figured out SFE doesn't work (it's enabled by default?) Note: SFE kills (makes it non working) the E1200v2. Status: Used for my Mom's work PC, but so far I haven't had any issues come back! Mode: Client Bridges, all settings not required turned off.įirmware: dd-wrt.v24-40260_NEWD-2_K3.x_mega-e1200v2.bin
0 kommentar(er)
